The range of services RAT can offer you

We offer a complete engine building service from fast road up to a full spec race motor. This includes cylinder block boring and decking,crank balancing,con rod polishing and flywheel lightening and machining for race clutches. Cylinder head rebuilding and gas flowing including fitting race springs and valves. Piston machining including valve cut outs and crown decking and supply Wossner forged pistons. We can supply and fit a full range of Kentcams camshafts and vernier pulley's. ARP rod bolts etc. Supply and fit aftermarket Throttle bodies, injectors and ECU's including wiring looms and engine mapping etc.

Jenvey twin throttle bodies from £490pr

DTA engine management from £550 (ECU only)

Wossner forged pistons From £499 for 4 piston set.

Cylinder head gas flowing from £200.

We can supply Cometic head gaskets for most makes.

We also supply Green Air Filters, direct replacement and Intake kits etc.

For more details of any of the above please call 01522 779233 or email rat.developments@ntlworld.com

We offer a full body shell prep service, including seam welding from £300.

Roll cage fitting from £400 (not including roll cage).

Full roll cage's supply only  from £250.

For more details please call 01522 779233 or email rat.developments@ntlworld.com

Suspension and brake modifications and rear axle fabrication.

Rear beam axles for Autograss, autocross and rallycross etc. From £1500 including hi-spec rose joints, CDS tubing, brakes and braided pipes. (not including suspension or hand brake).

For more details please call 01522 779233 or email rat.developments@ntlworld.com

Supply and fit engine management including fabrication of new wiring looms etc. We can also supply and fit ECU piggy back units to most common rail diesel cars, these units increase power by around 30bhp and increase fuel economy by around 10%.
we can also map engine management on our in house chassis dyno. Please see DYNO page for prices.